AnyCubic Water-Wash Resin + (Grey), AnyCubic
Сроки доставки
Товар заказывается со склада поставщика. Если поставщик не сможет доставить данный товар до указанной даты, мы информируем Вас по электронной почте.
 Доступно | Склад поставщика |
Доставка на дом
Доставка на дом
После передачи товара курьеру мы сообщим вам об этом по электронной почте.
Более 25,00 € (Заказы до 1000 кг) | Бесплатно |
К 25,00 € (Заказы до 1000 кг) | 4,50 € |
Получение в почтомате
Получение в почтомате
3,50 €
Описание товара от поставщика
AnyCubic Water-Wash Resin + (Gray)
AnyCubic Water-Wash Resin+ is a state-of-the-art resin that features high precision and minimal shrinkage during curing, allowing you to maintain detail in even the most complex models. Its unique formula provides strength and flexibility, making models resistant to cracking and mechanical damage. In addition, the prints can be stored for 3 years in natural conditions without the risk of cracking.
Low cost and high efficiency
AnyCubic Water-Wash Resin+ allows cleaning in 3 ways, eliminating the need for alcohol and IPA. This reduces cleaning costs and increases cleaning efficiency. You can clean models by ultrasonic, with a dedicated machine such as Wash & Cure from AnyCubic, or simply with water, allowing you to customize the process to your capabilities and needs.
Safety and comfort
The product has low odor emissions, making it pleasant to use. Suitable for those looking for materials with less environmental impact and safe for daily use.
Faster printing
Thanks to its lower viscosity, AnyCubic Water-Wash Resin+ offers faster printing and reduced exposure time, resulting in higher productivity. It is also compatible with a wide range of UV wavelengths (365-405nm), making it a universal choice for most 3D printers on the market.
Physical and Chemical Properties:
| UV wavelength: | 365-405 nm |
|---|---|
| Density: | 1.15-1.20 g/cm³ |
| Viscosity: | 150-250 mPa-s at 25°C |
| Hardness: | 80 Shore D |
| Tensile strength: | 30-45 MPa |
| Elongation at fracture: | 8%-15% |
| Elasticity at tension | 1600-1800 MPa |
| Flexural strength: | 50-60 MPa |
| Modulus of elasticity at bending: | 1500-1600 MPa |
| Exposure time for bottom layer: | 20-70s |
| Standard exposure time: | 1.5-10s |
Recommended printing parameters for different printer models:
| Layer thickness: | 0.05mm |
|---|---|
| Exposure time: | 1.5s to 8s |
| No-exposure time: | 5,5-2,5s |
| Exposure time of lower layers: | 20s to 35s |
| Number of lower layers: | 2-6 |
| Anti-aliasing: | 1/16 |
| Z Lift distance: | 4mm to 10mm |
| Z Lift speed: | 2mm/s to 6mm/s |
| Z Retract Speed: | 2mm/s do 6mm/s |
