Power over Ethernet (PoE) HAT for Raspberry Pi 3 Model B+ / 4B

Use this HAT to add PoE+ capability to your Raspberry Pi's Ethernet port. Compatible with Raspberry Pi 4 and Raspberry Pi 3B+. Power-sourcing equipment is required.

Specification

Standard: IEEE 802.3at-2009 PoE

Input voltage: 37-57 V DC, Class 4 device

Output power: 5 V DC/4 A

Cooling: 25 mm × 25 mm brushless fan delivering 2.2 CFM for processor cooling

Features: fully isolated switched-mode power supply; fan control

Operating temperature: 0 °C to +50 °C

Connecting your PoE+ HAT to your Raspberry Pi

Before installing the PoE+ HAT, you must attach the supplied spacers in the four corners of the board

Then connect the Raspberry Pi PoE+ HAT to the two 0.1" headers (40 + 4) that are fitted on your Raspberry Pi

Once the PoE+ HAT board is connected, you can power your Raspberry Pi through its RJ45 network connector

Disconnecting your PoE+ HAT

Take care when separating the HAT from your Raspberry Pi

Pull evenly so that it detaches from all the pins at the same rate; do not pull one end of the connector off before the other

Additional information

No modification to the main Raspberry Pi board is needed for this product to work. Please ensure that your Raspberry Pi’s software is up to date for all functionality to be available. The PoE+ HAT is fitted with a small fan that is controlled by your Raspberry Pi via I2C. The fan will turn on and off automatically depending on the temperature of the main processor on your Raspberry Pi.

Cap designed for Raspberry Pi 3B+ and 4B versions which are equipped with 4-pin PoE connector. It allows simultaneous communication with LAN and powering the minicomputer board. The input voltage of the module ranges from 37 V to 57 V. The output voltage is 5 V and the current capacity is 4 A.